Contact us

Add: 2Floor, Building A, Huilongda Industrial Park, Shuitian Community, Shiyan Street, Bao'an District, Shenzhen City, Guangdong Province, China

Tel: 0086 - 755 - 83570641

Fax: 0086 - 755 - 83570649

Jfopt Location: Jfopt > News > Fiber knowledge > How to Use Fiber-Optic Cable for CCTV

How to Use Fiber-Optic Cable for CCTV

Edit: fiber optic cables   Date: 2019-01-11

How to Use Fiber Optic Cable for CCTV


1. Place the fiber optic cable between the camera and your monitor. Multimode 2-strand fiber optic cable will be the most economical for a single camera installation. One strand will be used to carry the optical signals while the second strand will remain dormant and can be used as a backup in case the first strand should break. This camera/monitor link should not have any splices in the link.

2. Place one ST (straight tip) male fiber connector on each end of the fiber cable after the fiber cable is in place. Make sure to leave 18 inches of slack (coiled) at each end to accommodate equipment placement.

3. Place the FO transmitter at the camera location end of the fiber cable and the FO receiver at the monitor location end of the fiber cable. Neither of these devices is designed for outside use and must be protected from the elements. The transmitter at the camera location does not need to be next to the outdoor camera and can be located inside the building using the coaxial cable output between the camera and the transmitter to provide 10 to 20 feet of placement flexibility. The FO receiver located at the monitor is typically inside the structure. Remember that both the FO transmitter and the FO receiver will need available 110 VAC power outlets for the power supplies that power each of these devices.

4. Connect the FO transmitter to the camera using the pre-made coaxial cable jumper. You can also make your own coaxial jumper from a cut length of coaxial cable by adding two BNC (Bayonet Neill-Concelman) connectors, one at each end of this jumper.

5. Connect the external power supply to the FO transmitter.

6. Connect the FO receiver to the monitoring device using a coaxial cable jumper. This monitoring device can be a digital video recorder (DVR) or a video card in a computer. DVRs or video cards are typically configured with BNC connectors.

7. Connect the external power supply to the FO receiver.

8. Test this completed fiber-optic circuit to ensure your camera and monitor are functioning properly and the link is complete.

Related News
JFOPT | About us | Products | News | Jobs | Sitemap | Certificate

Hot Products:Fiber optical patch cables    Fiber cable supplier    Fiber optical splice closure    Fiber optical patch panel    Fiber test equipment  

CopyRight©JFOPT CO.,LTD.  Powered by: Fiber Optical Cable Fiber cable supplier In China